Lighting

First Time....
After the set-up of the unit is complete, use the following procedure to light the burner. First time lighting may take longer than usual due to the air that may be in the gas lines.

1. To start the refrigerator, turn the thermostat knob "B" (Thermostat) to the #3 setting
2. Turn button "C" (Gas Safety On/Off Valve) to the "On" Position.
3. Push and hold button "C" (Gas Safety On/Off Valve) for 10 seconds then press button "A" (Piezo Ignitor) to light burner. Confirm the flame is lit by viewing the burner directly or the On/Off Flame Indicator Gauge (if equipped) will move to the green side. It should be possible to hear a slight turbulent noise from the flame. If the burner is lit, continue holding button "C" for 5-15 seconds. Release button "C" and confirm the burner is still lit. If the burner does not light, repeat steps 1 and 2.

We recommend to take a good look at the flame upon initial start up and memorize the size and color for future reference. It is good practice to visually check the flame for this size and color upon every start up. If the flame is too small or discolored, refer to the trouble shooting section.

Hand Lighting....
If for some reason the unit will not light with the piezo ignition or the ignitor is failing to spark, it is possible to hand light the burner. This usually requires two people. Simply use the above procedure and replace button "A" with a person at the burner with a lighter. Refer to the Will not Light section.